The Speedzter3 is a Combo USB2.0 and Firewire external enclosure built-in high-performance serial buses up to 480Mbps (USB2.0 - USB1.1 compatible) and 400Mbps(IEEE-1394a). To insure the maximum compatible our Speedzter3 was designed with Oxford-911 and ISD300A.

Both of USB2.0 and FireWire/IEEE-1394 once connected to a computer a proper protocol/drivers automatic loaded and give the end user instant access.

Features:

• Convert any 3.5 inches form factor into Firewire and USB2.0 interface in a minute

• Supports Windows98SE, ME, 2000, XP, MAC 8.6 or higher Linux Kernel 2.4.2 (driver dependent)

• 100, 200, 400 Mbps Firewire transfer rate

• 12Mbps for USB1.1, 480 Mbps for USB2.0 transfer rate

• Hot-swapping capability, No ID, No termination

• More compact, less noise, and better heat dissipation due to the NEW aluminum body

Specification:

IDE peripherals:	Upto ATA-100: Hard Disk
Operating System:	Win98SE, ME, Win 2000, MAC 8.6 or higher
IDE Interface:	ATAPI/ATA-66: USB2.0 ATAPI/ATA-100: IEEE-1394/FireWire
IEEE 1394 Interface:	Oxford-911: IEEE 1394a compliant. Support data transfer rate up to 100, 200, 400 Mbps. SBP-2 Target Revision 4 compliant..
USB2.0 Interface:	ISD300A: USB2.0 EHCI based USB 2.0 compliant solution. transfer rate up to 12, 200, 480 Mbps,
Connectors:	IEC AC connector x 1 6-pin IEEE 1394 connector x 2 4-pin USB connector x 1 Power connector x 1 On/Off switch x 1
Power Requirement:	Universal AC adapter with Output at 12Vdc / 3A
Operating Temperature:	32o F to 122o F ; (0o C to 50o C)
Operating Humidity:	5% to 95% non-condensing
Dimension:	7.8 x 4.4 x 1.7 inch ; (19.8 cm x 11.2 cm x 4.4 cm)

Note: All trademarks and registered trademarks mentioned herein are the properly of their respective companies.